Home › Engine / Hybrid System › 1NR-FE ENGINE CONTROL › AIR FUEL RATIO SENSOR › from 2016.04
RM30M0E _51 Engine / Hybrid System _053310 1NR-FE ENGINE CONTROL _0260027 AIR FUEL RATIO SENSOR A

1NR-FE ENGINE CONTROL  AIR FUEL RATIO SENSOR  INSTALLATION  


PROCEDURE

Hide 89467B 1.INSTALL AIR FUEL RATIO SENSOR

a.
A381290C01
0.49,3.073 0.656,2.542 true 0.354,3.125 0.813,3.323 0.458,0.198 10 false SST 0.521,4.156 0.833,4.354 0.313,0.198 10 false *a 1.552,4.156 1.865,4.354 0.313,0.198 10 false *b
*a SST Fulcrum Length
*b Torque Wrench Fulcrum Length


Using SST, install the air fuel ratio sensor to the exhaust manifold converter sub-assembly.

SST
09224-00012  

Torque:
Specified tightening torque : 44 N*m (449 kgf*cm, 32 ft.*lbf)

NOTICE:

If a component has been dropped or subjected to a strong impact, replace the air fuel ratio sensor.


HINT:
·

Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION

·

When using SST (fulcrum length of 30 mm (1.18 in.)) + torque wrench (fulcrum length of 255 mm (10.0 in.)):

39 N*m (398 kgf*cm, 29 ft.*lbf)

·

Perform "Inspection After Repairs" after replacing the air fuel ratio sensor.

Click hereEngine / Hybrid System>1NR-FE ENGINE CONTROL>SFI SYSTEM>INITIALIZATION




b.

Engage the 2 clamps to connect the air fuel ratio sensor wire to the wire harness clamp bracket.


c.

Connect the air fuel ratio sensor connector.


Hide 2.INSPECT FOR EXHAUST GAS LEAK

a.

Perform "Inspection After Repairs" after repairing or replacing the exhaust system.

Click hereEngine / Hybrid System>1NR-FE ENGINE CONTROL>SFI SYSTEM>INITIALIZATION


Hide 3.PERFORM INITIALIZATION

a.

Perform "Inspection After Repairs" after replacing the air fuel ratio sensor.

Click hereEngine / Hybrid System>1NR-FE ENGINE CONTROL>SFI SYSTEM>INITIALIZATION