Home › Engine / Hybrid System › 1NR-FE ENGINE CONTROL › AIR FUEL RATIO SENSOR › from 2016.04
RM30M0E _51 Engine / Hybrid System _053310 1NR-FE ENGINE CONTROL _0260027 AIR FUEL RATIO SENSOR G

1NR-FE ENGINE CONTROL  AIR FUEL RATIO SENSOR  INSPECTION  


PROCEDURE

Hide 89467B 1.INSPECT AIR FUEL RATIO SENSOR

a.

Check the resistance.

i.
A171222C02
1.885,0.844 2.302,0.427 true 1.104,1.823 1.521,1.406 true 1.542,0.844 1.073,0.469 true 0.146,0.094 0.458,0.25 0.313,0.156 10 false *a 2.354,0.344 2.875,0.573 0.521,0.229 10 false HA1A 0.729,1.74 1.25,1.969 0.521,0.229 10 false A1A- 0.833,0.375 1.354,0.604 0.521,0.229 10 false +B
*a Component without harness connected
(Air Fuel Ratio Sensor)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 (HA1A) - 2 (+B) 20°C (68°F) 1.6 to 3.2 Ω
1 (HA1A) - 4 (A1A-) Always 10 kΩ or higher


If the result is not as specified, replace the air fuel ratio sensor.