89465
1.INSTALL HEATED OXYGEN SENSOR
| *a | SST Fulcrum Length |
| *b | Torque Wrench Fulcrum Length |
Using SST, install the heated oxygen sensor to the front exhaust pipe assembly.
If a component has been dropped or subjected to a strong impact, replace the heated oxygen sensor.
Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
When using SST (fulcrum length of 30 mm (1.18 in.)) + torque wrench (fulcrum length of 255 mm (10.0 in.)):
39 N*m (398 kgf*cm, 29 ft.*lbf)
Engage the clamp to connect the heated oxygen sensor wire to the wire harness clamp bracket.
Connect the heated oxygen sensor connector.
2.INSPECT FOR EXHAUST GAS LEAK
Perform "Inspection After Repairs" after replacing the air fuel ratio sensor.
Click hereEngine / Hybrid System>1NR-FE ENGINE CONTROL>SFI SYSTEM>INITIALIZATION