Home › Engine / Hybrid System › 2NR-FE ENGINE CONTROL › CAMSHAFT OIL CONTROL VALVE › from 2016.04
RM30M0E _51 Engine / Hybrid System _053304 2NR-FE ENGINE CONTROL _0260031 CAMSHAFT OIL CONTROL VALVE A

2NR-FE ENGINE CONTROL  CAMSHAFT OIL CONTROL VALVE  REMOVAL  


PROCEDURE

Hide 12611 1.REMOVE NO. 1 ENGINE COVER

a.
A381263

Disengage the 3 grommets to remove the No. 1 engine cover from the cylinder head cover sub-assembly.


Hide 11101J 2.REMOVE CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY (for Exhaust Side)

a.
A381701

Disconnect the camshaft timing oil control valve assembly connector.


b.

Remove the bolt and camshaft timing oil control valve assembly from the cylinder head cover sub-assembly.

NOTICE:
·

Do not allow foreign matter to contact the oil seal face of the camshaft timing oil control valve assembly (connecting surface with the cylinder head cover sub-assembly).

·

If the camshaft timing oil control valve assembly has been struck or dropped, replace it.




Hide 11101J 3.REMOVE CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY (for Intake Side)

a.
A381702

Disconnect the camshaft timing oil control valve assembly connector.


b.

Remove the bolt and camshaft timing oil control valve assembly from the cylinder head cover sub-assembly.

NOTICE:
·

Do not allow foreign matter to contact the oil seal face of the camshaft timing oil control valve assembly (connecting surface with the cylinder head cover sub-assembly).

·

If the camshaft timing oil control valve assembly has been struck or dropped, replace it.




Hide 15330A 4.REMOVE CAM TIMING OIL CONTROL VALVE O-RING

HINT:

This procedure is performed when the cam timing oil control valve O-ring must be replaced with a new one.


a.
A198003

Remove the cam timing oil control valve O-ring from the camshaft timing oil control valve assembly.