Home › Engine / Hybrid System › 2NR-FE ENGINE CONTROL › THROTTLE BODY › from 2016.04
RM30M0E _51 Engine / Hybrid System _053304 2NR-FE ENGINE CONTROL _0260032 THROTTLE BODY G

2NR-FE ENGINE CONTROL  THROTTLE BODY  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 22030 1.CHECK THROTTLE BODY WITH MOTOR ASSEMBLY

a.

Check the idle speed.

i.

Start the engine and check that the MIL is not illuminated. After the engine is warmed up, check that the idle speed is within the specified range with the A/C switch off (w/ air conditioning system).

Standard idle speed:
Transaxle Idle Speed
Continuously Variable Transaxle 680 to 780 rpm
Manual Transaxle 550 to 650 rpm


NOTICE:
·

Be sure to perform this step with all accessories off.

·

Make sure that the shift lever is in P or N (neutral).




ii.

Perform a road test and confirm that there are no abnormalities.



b.

Check the throttle position sensor.

i.

Connect the GTS to the DLC3.


ii.

Turn the ignition switch to ON.


iii.

Turn the GTS on.


iv.

Enter the following menus: Powertrain / Engine and ECT / Data List / Throttle Position No. 1 and Throttle Position No. 2.

Powertrain > Engine and ECT > Data List
Tester Display
Throttle Position No.1
Throttle Position No.2
50003 234 282,283

v.

Depress the accelerator pedal. When the throttle valve is fully open, check that the value of Throttle Sensor Position is as specified.

Standard Throttle Valve Opening Percentage:
Tester Display Specified Condition
Throttle Sensor Position 60% or higher


NOTICE:
·

When checking the throttle valve opening percentage, the shift lever should be in N (neutral).

·

Fully depress the accelerator pedal.



If the percentage is less than 60%, replace the throttle body with motor assembly.