Home › Engine / Hybrid System › 2NR-FE ENGINE CONTROL › ACCELERATOR PEDAL › from 2016.04
RM30M0E _51 Engine / Hybrid System _053304 2NR-FE ENGINE CONTROL _0260034 ACCELERATOR PEDAL A

2NR-FE ENGINE CONTROL  ACCELERATOR PEDAL  REMOVAL  


PROCEDURE

Hide 78110K 1.REMOVE ACCELERATOR PEDAL SENSOR ASSEMBLY

a.
A179627

Disconnect the accelerator pedal sensor assembly connector.


b.

Remove the 2 bolts and accelerator pedal sensor assembly from the vehicle.

NOTICE:
·

Do not disassemble the accelerator pedal sensor assembly.

·

If a component has been dropped or subjected to a strong impact, replace the accelerator pedal sensor assembly.

·

This accelerator pedal sensor assembly does not require lubrication. Do not apply oil or other lubrication to the accelerator pedal sensor assembly. If applied, the accelerator pedal sensor assembly must be replaced.