Home › Engine / Hybrid System › 2NR-FE ENGINE CONTROL › ACCELERATOR PEDAL › from 2016.04
RM30M0E _51 Engine / Hybrid System _053304 2NR-FE ENGINE CONTROL _0260034 ACCELERATOR PEDAL G

2NR-FE ENGINE CONTROL  ACCELERATOR PEDAL  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 78110K 1.INSPECT ACCELERATOR PEDAL SENSOR ASSEMBLY

a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the GTS on.


d.

Enter the following menus: Powertrain / Engine and ECT / Data List / Accel Sensor Out No. 1 and Accel Sensor Out No. 2.

Powertrain > Engine and ECT > Data List
Tester Display
Accel Sensor Out No.1
Accel Sensor Out No.2
50003 234 280,281

e.

Read the values displayed on the GTS.

Standard Voltage:
Tester Display Condition Specified Condition
Accel Sensor Out No. 1 Accelerator pedal is released 0.5 to 1.1 V
Accelerator pedal is fully depressed 2.5 to 4.5 V
Accel Sensor Out No. 2 Accelerator pedal is released 1.2 to 2.0 V
Accelerator pedal is fully depressed 3.4 to 4.7 V


If the result is not as specified, check the accelerator pedal sensor assembly, wire harness or ECM.