Home › Engine / Hybrid System › 2NR-FE ENGINE CONTROL › ENGINE COOLANT TEMPERATURE SENSOR › from 2016.04
RM30M0E _51 Engine / Hybrid System _053304 2NR-FE ENGINE CONTROL _0260039 ENGINE COOLANT TEMPERATURE SENSOR A

2NR-FE ENGINE CONTROL  ENGINE COOLANT TEMPERATURE SENSOR  INSTALLATION  


PROCEDURE

Hide 89422 1.INSTALL ENGINE COOLANT TEMPERATURE SENSOR

a.

Install a new gasket to the engine coolant temperature sensor.


b.
A381920E01
1.271,2.552 1.563,1.958 true 1.615,1.875 1.969,2.052 0.354,0.177 10 true SST

Using SST, install the engine coolant temperature sensor to the cylinder head sub-assembly.

SST
09817-33191  

Torque:
19.6 N*m (200 kgf*cm, 14 ft.*lbf)

NOTICE:

If a component has been dropped or subjected to a strong impact, replace the engine coolant temperature sensor.


HINT:

Perform "Inspection After Repairs" after replacing the engine coolant temperature sensor.

Click hereEngine / Hybrid System>2NR-FE ENGINE CONTROL>SFI SYSTEM>INITIALIZATION



c.

Connect the engine coolant temperature sensor connector.


Hide 4.PERFORM INITIALIZATION

a.

Perform "Inspection After Repairs" after replacing the engine coolant temperature sensor.

Click hereEngine / Hybrid System>2NR-FE ENGINE CONTROL>SFI SYSTEM>INITIALIZATION