Home › Engine / Hybrid System › 2NR-FE ENGINE CONTROL › KNOCK SENSOR › from 2016.04
RM30M0E _51 Engine / Hybrid System _053304 2NR-FE ENGINE CONTROL _0260040 KNOCK SENSOR A

2NR-FE ENGINE CONTROL  KNOCK SENSOR  INSTALLATION  


PROCEDURE

Hide 89615 1.INSTALL KNOCK SENSOR

a.
A171214E01
2.01,0.927 2.292,1.083 0.281,0.156 10 true 45° 1.948,1.344 2.229,1.5 0.281,0.156 10 true 15° 1.75,1.552 2.031,1.708 0.281,0.156 10 true 15°

Install the knock sensor to the cylinder block sub-assembly with the bolt as shown in the illustration.

Torque:
20 N*m (204 kgf*cm, 15 ft.*lbf)

NOTICE:
·

If a component has been dropped or subjected to a strong impact, replace the knock sensor.

·

Make sure that the knock sensor is in the correct position.



HINT:

Perform "Inspection After Repairs" after replacing the knock sensor.

Click hereEngine / Hybrid System>2NR-FE ENGINE CONTROL>SFI SYSTEM>INITIALIZATION



b.

Connect the knock sensor connector.


Hide 3.PERFORM INITIALIZATION

a.

Perform "Inspection After Repairs" after replacing the knock sensor.

Click hereEngine / Hybrid System>2NR-FE ENGINE CONTROL>SFI SYSTEM>INITIALIZATION