89467B
1.INSTALL AIR FUEL RATIO SENSOR
| *a | SST Fulcrum Length |
| *b | Torque Wrench Fulcrum Length |
Using SST, install the air fuel ratio sensor to the exhaust manifold converter sub-assembly.
If a component has been dropped or subjected to a strong impact, replace the air fuel ratio sensor.
Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
When using SST (fulcrum length of 30 mm (1.18 in.)) + torque wrench (fulcrum length of 255 mm (10.0 in.)):
39 N*m (398 kgf*cm, 29 ft.*lbf)
Perform "Inspection After Repairs" after replacing the air fuel ratio sensor.
Click hereEngine / Hybrid System>2NR-FE ENGINE CONTROL>SFI SYSTEM>INITIALIZATION
Engage the 2 clamps to connect the air fuel ratio sensor wire to the wire harness clamp bracket.
Connect the air fuel ratio sensor connector.
2.INSPECT FOR EXHAUST GAS LEAK
Perform "Inspection After Repairs" after repairing or replacing the exhaust system.
Click hereEngine / Hybrid System>2NR-FE ENGINE CONTROL>SFI SYSTEM>INITIALIZATION
3.PERFORM INITIALIZATION
Perform "Inspection After Repairs" after replacing the air fuel ratio sensor.
Click hereEngine / Hybrid System>2NR-FE ENGINE CONTROL>SFI SYSTEM>INITIALIZATION