Home › Engine / Hybrid System › 2NR-FE ENGINE CONTROL › HEATED OXYGEN SENSOR › from 2016.04
RM30M0E _51 Engine / Hybrid System _053304 2NR-FE ENGINE CONTROL _0260044 HEATED OXYGEN SENSOR A

2NR-FE ENGINE CONTROL  HEATED OXYGEN SENSOR  INSTALLATION  


PROCEDURE

Hide 89465 1.INSTALL HEATED OXYGEN SENSOR

a.
A381291C01
1.521,1.844 1.771,1.313 false 1.385,1.875 1.844,2.073 0.458,0.198 10 false SST 0.531,4.198 0.844,4.396 0.313,0.198 10 false *a 1.563,4.198 1.875,4.396 0.313,0.198 10 false *b
*a SST Fulcrum Length
*b Torque Wrench Fulcrum Length


Using SST, install the heated oxygen sensor to the front exhaust pipe assembly.

SST
09224-00012  

Torque:
Specified tightening torque : 44 N*m (449 kgf*cm, 32 ft.*lbf)

NOTICE:

If a component has been dropped or subjected to a strong impact, replace the heated oxygen sensor.


HINT:
·

Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION

·

When using SST (fulcrum length of 30 mm (1.18 in.)) + torque wrench (fulcrum length of 255 mm (10.0 in.)):

39 N*m (398 kgf*cm, 29 ft.*lbf)




b.

Engage the clamp to connect the heated oxygen sensor wire to the wire harness clamp bracket.


c.

Connect the heated oxygen sensor connector.


Hide 2.INSPECT FOR EXHAUST GAS LEAK

Perform "Inspection After Repairs" after replacing the air fuel ratio sensor.

Click hereEngine / Hybrid System>2NR-FE ENGINE CONTROL>SFI SYSTEM>INITIALIZATION