Home › Engine / Hybrid System › 2NR-FE ENGINE CONTROL › HEATED OXYGEN SENSOR › from 2016.04
RM30M0E _51 Engine / Hybrid System _053304 2NR-FE ENGINE CONTROL _0260044 HEATED OXYGEN SENSOR A

2NR-FE ENGINE CONTROL  HEATED OXYGEN SENSOR  REMOVAL  


PROCEDURE

Hide 89465 1.REMOVE HEATED OXYGEN SENSOR

a.
A383780C01
0.125,2.51 0.5,2.75 0.375,0.24 12 true *B 0.083,0.094 0.458,0.333 0.375,0.24 12 true *A
*A for CVT
*B for Manual Transaxle


Disconnect the heated oxygen sensor connector.


b.

Disengage the clamp to disconnect the heated oxygen sensor wire from the wire harness clamp bracket.


c.
A386635E01
1.646,1.906 1.74,1.594 true 1.51,1.938 1.969,2.135 0.458,0.198 10 false SST

Using SST, remove the heated oxygen sensor from the front exhaust pipe assembly.

SST
09224-00012  

NOTICE:

If a component has been dropped or subjected to a strong impact, replace the heated oxygen sensor.