84210
1.INSPECT BACK-UP LIGHT SWITCH ASSEMBLY
Check the resistance.
| *a | Component without harness connected
(Back-up Light Switch Assembly) |
| *b | 1.1 mm (0.0433 in.) |
| *c | On |
| *d | Off |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| 1 - 2 | On (Pushed in) | Below 1 Ω |
| Off (Released) | 10 kΩ or higher |
If the result is not as specified, replace the back-up light switch assembly.