Home › Engine / Hybrid System › 1NR-FE ENGINE MECHANICAL › FRONT CRANKSHAFT OIL SEAL › from 2016.04
RM30M0E _51 Engine / Hybrid System _053932 1NR-FE ENGINE MECHANICAL _0262344 FRONT CRANKSHAFT OIL SEAL A

1NR-FE ENGINE MECHANICAL  FRONT CRANKSHAFT OIL SEAL  REMOVAL  


PROCEDURE

Hide 1.REMOVE FRONT WHEEL RH

Hide 51441C 2.REMOVE ENGINE UNDER COVER RH (w/o Metal Type Under Cover)

Hide 51451A 3.REMOVE CENTER ENGINE UNDER COVER (w/ Metal Type Under Cover)

Hide 51405A 4.REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY (w/ Metal Type Under Cover)

Hide 16361A 5.REMOVE FAN AND GENERATOR V BELT

Hide 13471 6.REMOVE CRANKSHAFT PULLEY

a.
A380915C01
2.552,1.427 2.875,1.25 true 2.542,1.865 2.854,2.021 0.313,0.156 10 false *a 2.042,1.865 2.354,2.021 0.313,0.156 10 true *b 2.906,1.167 3.365,1.365 0.458,0.198 10 true SST
*a Hold
*b Turn


Using SST, hold the crankshaft pulley.

SST
09960-10010  (09962-01000, 09963-01000)


b.

Remove the crankshaft pulley bolt and crankshaft pulley from the crankshaft.


Hide 11302A 7.REMOVE TIMING CHAIN COVER OIL SEAL

a.
A306576C01
1.24,1.969 1.573,2.552 true 2.25,2.479 2.708,2.771 2.708,2.771 3.125,2.479 false 2.625,2.802 2.938,2.958 0.313,0.156 10 false *a 1.531,2.594 1.844,2.75 0.313,0.156 10 false *b
*a Cut Position
*b Protective Tape


Using a knife, cut off the lip of the timing chain cover oil seal.


b.

Using a screwdriver with its tip wrapped in protective tape, pry out the timing chain cover oil seal from the timing chain cover assembly.

NOTICE:

After removing, check the crankshaft and timing chain cover assembly for damage. If damaged, smooth the surface with 400-grit sandpaper.