Home › Engine / Hybrid System › 1NR-FE ENGINE MECHANICAL › FRONT CRANKSHAFT OIL SEAL › from 2016.04
RM30M0E _51 Engine / Hybrid System _053932 1NR-FE ENGINE MECHANICAL _0262344 FRONT CRANKSHAFT OIL SEAL A

1NR-FE ENGINE MECHANICAL  FRONT CRANKSHAFT OIL SEAL  INSTALLATION  


PROCEDURE

Hide 11302A 1.INSTALL TIMING CHAIN COVER OIL SEAL

a.

Apply MP grease to the lip of a new timing chain cover oil seal.

NOTICE:

Keep the lip free of foreign matter.



b.
A300626E01
1.417,1.792 1.052,1.219 true 2.177,0.833 1.865,0.417 true 0.729,1.125 1.094,1.292 0.365,0.167 10 false SST 1.531,0.333 1.896,0.5 0.365,0.167 10 false SST 2.979,0.229 3.135,0.427 0.156,0.198 10 false + 2.417,0.229 2.573,0.427 0.156,0.198 10 false -

Using SST and a hammer, tap in the timing chain cover oil seal until its surface is flush with the timing chain cover sub-assembly.

SST
09223-22010  

Timing chain cover oil seal tap in depth:

-0.5 to 1.0 mm (-0.0197 to 0.0394 in.)


NOTICE:
·

Do not tap in the timing chain cover oil seal at an angle.

·

Wipe off excess grease from the crankshaft.




Hide 13471 2.INSTALL CRANKSHAFT PULLEY

a.
A380916C01
1.021,1.438 1.479,1.667 true 1.208,1.854 1.406,2.021 0.198,0.167 10 true *a 2.156,1.979 2.365,2.156 0.208,0.177 10 false *b 0.688,1.313 1.031,1.49 0.344,0.177 10 true SST
*a Hold
*b Turn


Align the pulley set key with the key groove of the crankshaft pulley, then temporarily install the crankshaft pulley and crankshaft pulley bolt to the crankshaft.


b.

Using SST, hold the crankshaft pulley.

SST
09960-10010  (09962-01000, 09963-01000)


c.

Fully tighten the crankshaft pulley bolt.

Torque:
164 N*m (1672 kgf*cm, 121 ft.*lbf)


Hide 16361A 3.INSTALL FAN AND GENERATOR V BELT

Hide 51441C 5.INSTALL ENGINE UNDER COVER RH (w/o Metal Type Under Cover)

Hide 51405A 6.INSTALL NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY (w/ Metal Type Under Cover)

Hide 51451A 7.INSTALL CENTER ENGINE UNDER COVER (w/ Metal Type Under Cover)

Hide 8.INSTALL FRONT WHEEL RH

Torque:
103 N*m (1050 kgf*cm, 76 ft.*lbf)