Home › Engine / Hybrid System › 1NR-FE STARTING › STARTER › from 2016.04
RM30M0E _51 Engine / Hybrid System _053949 1NR-FE STARTING _0262381 STARTER A

1NR-FE STARTING  STARTER  INSTALLATION  


PROCEDURE

Hide 1.INSTALL FLYWHEEL HOUSING SIDE COVER

a.

Install the flywheel housing side cover to the cylinder block sub-assembly.


Hide 28100 2.INSTALL STARTER ASSEMBLY

a.

Install the starter assembly to the cylinder block sub-assembly with the 2 bolts.

Torque:
37 N*m (377 kgf*cm, 27 ft.*lbf)


b.

Connect the terminal 50 connector.


c.

Connect the terminal 30 to the magnet starter switch assembly with the nut.

Torque:
9.8 N*m (100 kgf*cm, 87 in.*lbf)


d.

Close the terminal cap.


Hide 3.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque:
5.4 N*m (55 kgf*cm, 48 in.*lbf)