Home › Engine / Hybrid System › 1NR-FE STARTING › STARTER › from 2016.04
RM30M0E _51 Engine / Hybrid System _053949 1NR-FE STARTING _0262381 STARTER A

1NR-FE STARTING  STARTER  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notice before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

Hide 28100 3.REMOVE STARTER ASSEMBLY

A331198

a.

Open the terminal cap.


b.

Remove the nut to disconnect the terminal 30 from the magnet starter switch assembly.


c.

Disconnect the terminal 50 connector.


d.

Remove the 2 bolts and starter assembly from the cylinder block sub-assembly.


Hide 4.REMOVE FLYWHEEL HOUSING SIDE COVER

A285694

a.

Remove the flywheel housing side cover from the cylinder block sub-assembly.