Home › Engine / Hybrid System › 1NR-FE STARTING › STARTER › from 2016.04
RM30M0E _51 Engine / Hybrid System _053949 1NR-FE STARTING _0262381 STARTER A

1NR-FE STARTING  STARTER  DISASSEMBLY  


PROCEDURE

Hide 28150 1.REMOVE MAGNET STARTER SWITCH ASSEMBLY

a.
A331200

Using a 7 mm socket wrench, remove the 2 bolts.


b.
A331201C01
1.031,2.615 1.292,2.615 true 0.865,2.521 1.177,2.677 0.313,0.156 10 false *a
*a Terminal C


While lifting the rear of the magnet starter switch assembly, disconnect terminal C.


c.
A331202C01
1.385,0.573 1.552,0.458 1.552,0.458 1.677,0.458 false 1.313,1.417 1.49,1.417 1.49,1.417 1.677,1.156 false 1.719,0.365 2.052,0.552 0.333,0.188 10 false *a 1.135,1.333 1.448,1.49 0.313,0.156 10 false *b
*a Drive Lever
*b Hook


While lifting the rear of the magnet starter switch assembly, remove the hook from the drive lever, and then remove the magnet starter switch assembly.


Hide 28120 2.REMOVE STARTER YOKE ASSEMBLY

a.
A331203

Using a 7 mm socket wrench, remove the 3 through bolts.


b.

Remove the starter yoke assembly.


Hide 28140 3.REMOVE STARTER BRUSH HOLDER ASSEMBLY

a.
A248647

Remove the commutator end frame.


b.
A248649C08
1.594,0.813 1.208,0.813 false 1,0.729 1.167,0.885 0.167,0.156 10 *a
*a Hammer


While holding down the starter armature assembly and the starter brush holder assembly with the handle of a hammer, remove the starter yoke assembly.

HINT:

The starter armature assembly will be attracted by the magnetic field of the starter yoke assembly, so hold the starter armature assembly with the handle of the hammer.



Hide 28160 4.REMOVE STARTER ARMATURE ASSEMBLY

a.
A248650

Remove the starter armature assembly from the starter brush holder assembly.


Hide 28021 5.REMOVE STARTER CENTER BEARING CLUTCH SUB-ASSEMBLY

a.
A379538

Remove the rubber seal from the starter drive housing.


b.
A379539

Remove the starter center bearing clutch sub-assembly from the starter drive housing.


c.
A379540

Detach the 3 claws and remove the internal gear from the starter center bearing clutch sub-assembly.


d.
A331235

Remove the 3 planetary gears from the starter center bearing clutch sub-assembly.