Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › VSC OFF SWITCH › 2016.04–2017.10
RM30M0E _54 Brake _017098 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0262397 VSC OFF SWITCH G

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  VSC OFF SWITCH  INSPECTION  


PROCEDURE

Hide 1.INSPECT VSC OFF SWITCH

a.

Check the resistance.

i.
C311100C06
1.25,2.583 1.521,2.104 true 2.667,2.052 2.167,2.052 true 1.635,2.583 1.719,2.083 true 2.083,2.583 1.917,2.083 true 0.49,0.573 0.802,0.771 0.313,0.198 10 false *a 1.177,2.604 1.49,2.802 0.313,0.198 10 false + 2.708,1.979 3.021,2.177 0.313,0.198 10 false E 1.521,2.604 1.854,2.802 0.333,0.198 10 false ILL+ 2.031,2.615 2.365,2.813 0.333,0.198 10 false ILL-
*a Component without harness connected
(VSC OFF Switch)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition
9 (+) - 6 (E) Switch pushed Below 1 Ω
9 (+) - 6 (E) Switch not pushed 10 kΩ or higher




b.

Check that the illumination light.

i.

Apply battery voltage to the VSC OFF switch and check that the switch illuminates.

OK:
Condition Specified Condition
Battery positive (+) → Terminal 8 (ILL+)
Battery negative (-) → Terminal 7 (ILL-)
Illuminates


If the result is not as specified, replace the VSC OFF switch.