13716
1.REMOVE VALVE STEM CAP
Remove the valve stem caps from the intake valves and exhaust valves.
Arrange the removed parts in the correct order.
13711
2.REMOVE INTAKE VALVE
| *a | Wooden Block |
Using SST and wooden blocks, compress and remove the valve spring retainer locks from the valve spring retainers.
Arrange the removed parts in the correct order.
Remove the valve spring retainers, outer compression springs and intake valves from the cylinder head sub-assembly.
Arrange the removed parts in the correct order.
13715
3.REMOVE EXHAUST VALVE
| *a | Wooden Block |
Using SST and wooden blocks, compress and remove the valve spring retainer locks from the valve spring retainers.
Arrange the removed parts in the correct order.
Remove the valve spring retainers, outer compression springs and exhaust valves from the cylinder head sub-assembly.
Arrange the removed parts in the correct order.
4.REMOVE VALVE STEM OIL SEAL
Using needle-nose pliers, remove the valve stem oil seals from the intake valve guide bushes and exhaust valve guide bushes.
13734
5.REMOVE VALVE SPRING SEAT
Using compressed air and a Magnet Hand, remove the valve spring seats from the cylinder head sub-assembly by blowing air onto them.