1.REPLACE RING PIN
It is not necessary to remove the ring pins unless they are being replaced.
Remove the 2 ring pins from the cylinder block sub-assembly.
| *a | Upper Side |
Using a plastic hammer, tap in 2 new ring pins to the cylinder block sub-assembly.
6.0 to 7.0 mm (0.237 to 0.275 in.)
2.REPLACE STRAIGHT PIN
It is not necessary to remove the straight pins unless they are being replaced.
Remove the 5 straight pins from the cylinder block sub-assembly.
Using a plastic hammer, tap in 5 new straight pins to the cylinder block sub-assembly.
| *a | Front Side | *b | Rear Side |
| Item | Protrusion Height |
|---|---|
| Pin A | 5.5 to 6.5 mm (0.217 to 0.256 in.) |
| Pin B | 23.5 to 24.5 mm (0.925 to 0.965 in.) |
| Pin C | 11.5 to 12.5 mm (0.453 to 0.492 in.) |