Home › Engine / Hybrid System › 2NR-FE ENGINE MECHANICAL › ENGINE UNIT › from 2016.04
RM30M0E _51 Engine / Hybrid System _053933 2NR-FE ENGINE MECHANICAL _0262437 ENGINE UNIT A

2NR-FE ENGINE MECHANICAL  ENGINE UNIT  REMOVAL  


PROCEDURE

Hide 25051 2.REMOVE EXHAUST MANIFOLD CONVERTER SUB-ASSEMBLY

Hide 23814B 3.REMOVE FUEL DELIVERY PIPE

Hide 23891 4.REMOVE FUEL DELIVERY SPACER

Hide 5.REMOVE FUEL INJECTOR ASSEMBLY

Hide 12261 6.REMOVE VENTILATION HOSE

a.
A381512

Disengage the 2 clamps to disconnect the ventilation hose from the hose clamp.


b.

Slide the 2 hose clips and remove the ventilation hose from the cylinder head cover sub-assembly and intake manifold.


Hide 16267 7.DISCONNECT NO. 3 WATER BY-PASS HOSE

A312277

a.

Slide the hose clip and disconnect the No. 3 water by-pass hose from the throttle body with motor assembly.


Hide 16264 8.DISCONNECT NO. 2 WATER BY-PASS HOSE

A314369

a.

Slide the hose clip and disconnect the No. 2 water by-pass hose from the cylinder head sub-assembly.


Hide 9.REMOVE INTAKE MANIFOLD WITH THROTTLE BODY WITH MOTOR ASSEMBLY

A381449

a.

Remove the 3 bolts, 2 nuts and intake manifold with throttle body with motor assembly from the cylinder head sub-assembly.


b.

Remove the No. 1 intake manifold to head gasket from the intake manifold.


Hide 11.REMOVE NO. 2 VENTILATION HOSE

A381477

a.

Slide the hose clip and remove the No. 2 ventilation hose from the cylinder head cover sub-assembly.


Hide 16268 12.REMOVE NO. 1 WATER BY-PASS PIPE

a.
A312280

Disengage the clamp to disconnect the water by-pass hose from the hose clamp.


b.

Remove the bolt to separate the No. 1 water by-pass pipe from the cylinder block sub-assembly.


c.

Slide the hose clip, disconnect the No. 1 water by-pass hose to remove the No. 1 water by-pass pipe from the water inlet with thermostat sub-assembly.


Hide 16620 13.REMOVE V-RIBBED BELT TENSIONER ASSEMBLY

a.
A312281

Remove the 2 bolts and V-ribbed belt tensioner assembly from the timing chain cover assembly.


Hide 14.REMOVE WIRE HARNESS CLAMP BRACKET

a.
A381463

Remove the bolt and wire harness clamp bracket from the cylinder head cover sub-assembly.


b.
A312283

Remove the 2 bolts and 2 wire harness clamp brackets from the cylinder head sub-assembly.


c.
A312284

Remove the bolt and wire harness clamp bracket from the cylinder block sub-assembly.