Home › Brake › BRAKE SYSTEM (OTHER) › VACUUM SWITCHING VALVE › 2016.04–2016.10
RM30M0E _54 Brake _017099 BRAKE SYSTEM (OTHER) _0092760 VACUUM SWITCHING VALVE G

BRAKE SYSTEM (OTHER)  VACUUM SWITCHING VALVE  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 25860D 1.INSPECT NO. 2 VACUUM SWITCHING VALVE ASSEMBLY (for 1NZ-FE, 2NZ-FE)

a.
C282669

Loosen the hose clip and disconnect the No. 2 air hose (connected to the air cleaner) from the No. 2 vacuum switching valve assembly.


b.

Move the shift lever to P and apply the parking brake.


c.

Connect the GTS to the DLC3, and then turn the ignition switch to ON.


d.

Enter the following menus: Powertrain / Engine and ECT / Active Test / Activate the Brake Ejector VSV.

Powertrain > Engine and ECT > Active Test
Tester Display
Activate the Brake Ejector VSV
50004 234 173

e.

Start the engine.


f.

Using the GTS, turn off the No. 2 vacuum switching valve assembly (Brake Ejector VSV: CLOSE).


g.

Use your finger to confirm that the No. 2 vacuum switching valve assembly has no suction.


h.

Using the GTS, turn on the No. 2 vacuum switching valve assembly (Brake Ejector VSV: OPEN).


i.

Use your finger to confirm that the No. 2 vacuum switching valve assembly has suction.


j.

Connect the No. 2 air hose to the No. 2 vacuum switching valve assembly.


Hide 25860D 2.INSPECT NO. 2 VACUUM SWITCHING VALVE ASSEMBLY (for 1NR-FE, 2NR-FE)

a.
C356873

Slide the hose clip and disconnect the No. 1 air hose from the No. 2 vacuum switcing valve assembly.


b.

Move the shift lever to P and apply the parking brake.


c.

Connect the GTS to the DLC3, and then turn the engine switch on (IG).


d.

Enter the following menus: Powertrain / Engine and ECT / Active Test / Activate the Brake Ejector VSV.

Powertrain > Engine and ECT > Active Test
Tester Display
Activate the Brake Ejector VSV
50004 234 173

e.

Start the engine.


f.

Using the GTS, turn off the No. 2 vacuum switcing valve assembly (Brake Ejector VSV: CLOSE).


g.

Use your finger to confirm that the No. 2 vacuum switcing valve assembly has no suction.


h.

Using the GTS, turn on the No. 2 vacuum switcing valve assembly (Brake Ejector VSV: OPEN).


i.

Use your finger to confirm that the No. 2 vacuum switcing valve assembly has suction.


j.

Connect the No. 1 air hose to the No. 2 vacuum switcing valve assembly and slide the hose clip to secure it.