33557A
1.REMOVE NO. 1 SELECTING BELLCRANK DUST COVER
Remove the No. 1 selecting bellcrank dust cover from the selecting bellcrank.
33534G
2.REMOVE NO. 2 SELECTING BELLCRANK PLATE WASHER
Remove the nut, washer and No. 2 selecting bellcrank plate washer from the selecting bellcrank support sub-assembly.
33534E
3.REMOVE NO. 2 SELECTING BELLCRANK
Remove the No. 2 selecting bellcrank from the selecting bellcrank.
33558
4.REMOVE NO. 2 SELECTING BELLCRANK DUST COVER
Remove the No. 2 selecting bellcrank dust cover from the selecting bellcrank.
33534F
5.REMOVE NO. 2 SELECTING BELLCRANK BUSH
Remove the 2 No. 2 selecting bellcrank bushes from the selecting bellcrank.
33277
6.REMOVE NO. 2 SELECT SPRING SEAT
Fix the shift and select lever shaft in a vise between aluminum plates.
Do not overtighten the vise.
Change the positions of the parts fixed in the vise as necessary to allow parts to be removed.
Using a screwdriver, remove the E-ring, No. 2 select spring seat and compression spring from the shift and select lever shaft.
33252A
7.REMOVE INNER NO. 2 SHIFT LEVER
Using a 5 mm pin punch and a hammer, remove the inner No. 2 shift lever slotted spring pin and inner No. 2 shift lever from the shift and select lever shaft.
Check the orientation of the inner No. 2 shift lever.
33251A
8.REMOVE INNER NO. 1 SHIFT LEVER
Using a 5 mm pin punch and a hammer, remove the inner No. 1 shift lever slotted spring pin, inner No. 1 shift lever and shift interlock plate from the shift and select lever shaft.
Check the orientation of the inner No. 1 shift lever.
33256
9.REMOVE SELECT INNER LEVER
Using a 5 mm pin punch and a hammer, remove the select inner lever slotted spring pin, select inner lever, compression spring and No. 1 select spring seat from the shift and select lever shaft.
Check the orientation of the select inner lever.
33276H
10.REMOVE NO. 1 SELECT SPRING SEAT SHAFT SNAP RING
Using 2 screwdrivers and a hammer, remove the No. 1 select spring seat shaft snap ring from the shift and select lever shaft.
Use a piece of cloth to keep the No. 1 select spring seat shaft snap ring from flying off.
33528B
11.REMOVE CONTROL SHAFT COVER
Remove the control shaft cover from the shift and select lever shaft.
33531B
12.REMOVE SHIFT AND SELECT LEVER SHAFT DUST BOOT
Remove the shift and select lever shaft dust boot from the shift and select lever shaft.
33528C
13.REMOVE CONTROL SHAFT COVER OIL SEAL
| *a | Protective Tape |
Using a screwdriver with its tip wrapped in protective tape, remove the control shaft cover oil seal from the control shaft cover.
Make sure not to damage the inside of the control shaft cover.