Home › Drivetrain › C50 MANUAL TRANSMISSION / TRANSAXLE › SPEEDOMETER SENSOR(for 1NZ-FE) › 2016.04–2016.07
RM30M0E _52 Drivetrain _017090 C50 MANUAL TRANSMISSION / TRANSAXLE _0262549 SPEEDOMETER SENSOR(for 1NZ-FE) G

C50 MANUAL TRANSMISSION / TRANSAXLE  SPEEDOMETER SENSOR(for 1NZ-FE)  INSPECTION  


PROCEDURE

Hide 83181G 1.INSPECT SPEEDOMETER SENSOR

a.

Check the voltage.

i.
C186417C01
1,0.875 1.542,0.875 true 1.115,0.563 1.729,0.854 true 1.219,0.271 1.896,0.844 true 0.167,0.135 0.479,0.292 0.313,0.156 10 false *a 0.844,0.167 1.302,0.365 0.458,0.198 10 false 3 (SI) 0.688,0.448 1.146,0.646 0.458,0.198 10 false 2 (SE) 0.552,0.771 1.052,0.969 0.5,0.198 10 false 1 (IG+)
*a Component without harness connected
(Speedometer Sensor)


Connect the positive (+) lead from the battery to terminal 1 (IG+) and the negative (-) lead to terminal 2 (SE).


ii.

Measure the voltage between terminals 3 (SI) and 2 (SE) while rotating the speedometer sensor shaft.

Standard Voltage:
Tester Connection Condition Specified Condition
3 (SI) - 2 (SE) Low signal Below 1 V
High signal 11 to 14 V


If the result is not as specified, replace the speedometer sensor.

HINT:

The voltage output oscillates more than 4 times every revolution of the speedometer sensor shaft.