83181G
1.INSPECT SPEEDOMETER SENSOR
Check the voltage.
| *a | Component without harness connected
(Speedometer Sensor) |
Connect the positive (+) lead from the battery to terminal 1 (IG+) and the negative (-) lead to terminal 2 (SE).
Measure the voltage between terminals 3 (SI) and 2 (SE) while rotating the speedometer sensor shaft.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 3 (SI) - 2 (SE) | Low signal | Below 1 V |
| High signal | 11 to 14 V |
If the result is not as specified, replace the speedometer sensor.
The voltage output oscillates more than 4 times every revolution of the speedometer sensor shaft.