Home › Engine / Hybrid System › 1NR-FE LUBRICATION › OIL PRESSURE SWITCH › from 2016.04
RM30M0E _51 Engine / Hybrid System _054016 1NR-FE LUBRICATION _0262594 OIL PRESSURE SWITCH A

1NR-FE LUBRICATION  OIL PRESSURE SWITCH  INSTALLATION  


PROCEDURE

Hide 83530 1.INSTALL ENGINE OIL PRESSURE SWITCH ASSEMBLY

a.

Clean and degrease the threads of the engine oil pressure switch assembly and threaded hole of the cylinder block sub-assembly.


b.
A314368C01
1.99,0.802 1.333,0.49 false 1.115,0.365 1.427,0.563 0.313,0.198 10 false *a
*a Adhesive


Apply adhesive to 2 or 3 threads of the engine oil pressure switch assembly.

Adhesive:

Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent


NOTICE:

To prevent contamination by foreign matter, install immediately after applying adhesive.



c.
A312259C01
1.365,1.792 1.563,1.281 true 1.26,1.802 1.573,1.958 0.313,0.156 10 false *a
*a 24 mm Deep Socket Wrench


Using a 24 mm deep socket wrench, install the engine oil pressure switch assembly to the cylinder block sub-assembly.

Torque:
15 N*m (153 kgf*cm, 11 ft.*lbf)

NOTICE:

Do not start the engine for at least 1 hour after installation.



d.

Connect the engine oil pressure switch assembly connector.