Home › Engine / Hybrid System › 2NR-FE LUBRICATION › OIL AND OIL FILTER › from 2016.04
RM30M0E _51 Engine / Hybrid System _054017 2NR-FE LUBRICATION _0262597 OIL AND OIL FILTER A

2NR-FE LUBRICATION  OIL AND OIL FILTER  REPLACEMENT  


CAUTION / NOTICE / HINT

CAUTION:
·

Prolonged and repeated contact with engine oil will result in the removal of natural oils from the skin, leading to dryness, irritation and dermatitis. Used engine oil contains potentially harmful contaminants which may cause skin cancer.

·

Take precautions when replacing engine oil to minimize the risk of your skin making contact with used engine oil. Wear protective clothing and gloves that cannot be penetrated by oil. Wash skin with soap and water, or use waterless hand cleaner, to completely remove any used engine oil. Do not use gasoline, thinner, or solvents.

·

Dispose of used oil and used oil filters at designated disposal sites in order to preserve the environment.



PROCEDURE

Hide 1.DRAIN ENGINE OIL

a.

Remove the oil filler cap sub-assembly from the cylinder head cover sub-assembly.


b.

Remove the oil pan drain plug and gasket from the oil pan sub-assembly, and drain the engine oil into a container.


c.

Clean and install the oil pan drain plug with a new gasket to the oil pan sub-assembly.

Torque:
30 N*m (306 kgf*cm, 22 ft.*lbf)


Hide 15601 2.REMOVE OIL FILTER SUB-ASSEMBLY

a.
A312254E01
0.865,1.375 1.448,1.219 true 0.552,1.302 0.885,1.5 0.333,0.198 10 true SST

Using SST, remove the oil filter sub-assembly from the oil filter union.

SST
09228-06502  


Hide 15601 3.INSTALL OIL FILTER SUB-ASSEMBLY

a.

Clean the oil filter sub-assembly installation surface.


b.

Apply clean engine oil to the gasket of a new oil filter sub-assembly.


c.

Lightly screw the oil filter sub-assembly into place by hand. Temporarily tighten oil filter sub-assembly until the gasket contacts the seat.

NOTICE:

Be careful that the O-ring does not get caught between the parts.



d.

Using SST, tighten the oil filter sub-assembly.

SST
09228-06502  

Torque:

15 N*m (153 kgf*cm, 11 ft.*lbf)



Hide 4.ADD ENGINE OIL

a.

Add new engine oil.

Standard Oil Grade
Oil Grade Oil Viscosity (SAE)
API grade SL "Energy-Conserving", SM "Energy-Conserving", SN "Resource-Conserving" or ILSAC multigrade engine oil
·

0W-20

·

5W-20

·

5W-30

·

10W-30


API grade SL, SM or SN multigrade engine oil
·

15W-40

·

20W-50*



NOTICE:

*: This grade of engine oil cannot be used for Euro IV or higher.


Standard Capacity
Item Standard Condition
Drain and refill with oil filter change 3.3 liters (3.4 US qts, 2.8 Imp. qts)
Drain and refill without oil filter change 3.1 liters (3.3 US qts, 2.7 Imp. qts)
Dry fill 3.9 liters (4.1 US qts, 3.4 Imp. qts)


b.

Install the oil filler cap sub-assembly to the cylinder head cover sub-assembly.


Hide 5.INSPECT FOR ENGINE OIL LEAK

a.

Start the engine. Make sure that there are no engine oil leaks from the area that was worked on.