Home › Engine / Hybrid System › 2NR-FE LUBRICATION › OIL PRESSURE SWITCH › from 2016.04
RM30M0E _51 Engine / Hybrid System _054017 2NR-FE LUBRICATION _0262598 OIL PRESSURE SWITCH G

2NR-FE LUBRICATION  OIL PRESSURE SWITCH  INSPECTION  


PROCEDURE

Hide 83530 1.INSPECT ENGINE OIL PRESSURE SWITCH ASSEMBLY

a.

Check the resistance.

i.

Disconnect the engine oil pressure switch assembly connector.


ii.

Start the engine.


iii.
A159695

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 - Switch body Idling 10 kΩ or higher
1 - Switch body Engine stopped Below 1 Ω


If the result is not as specified, replace the engine oil pressure switch assembly.


iv.

Connect the engine oil pressure switch assembly connector.