COMBINATION METER ASSEMBLY
Disconnect the combination meter assembly connector.
Measure the voltage and resistance of the wire harness side connector.
| Terminal No. (Symbol) | Wiring Color | Terminal Description | Condition | Specified Condition |
|---|---|---|---|---|
| F38-40 (B) - Body ground | B - Body ground | Battery | Always | 11 to 14 V |
| F38-39 (IG+) - Body ground | SB - Body ground | Ignition switch signal | Ignition switch off → ON | Below 1 V → 11 to 14 V |
| F38-21 (ED) - Body ground | W-B - Body ground | Ground | Always | Below 1 Ω |
If the result is not as specified, there may be a malfunction in the wire harness.
Reconnect the combination meter assembly connector.
Measure the voltage of the wire harness side connector.
| Terminal No. (Symbol) | Wiring Color | Terminal Description | Condition | Specified Condition |
|---|---|---|---|---|
| F38-24 (L) - Body ground | P - Body ground | Front seat inner belt assembly (driver side) signal | Ignition switch ON
Front seat belt (Driver Side) is unfastened |
Below 1 V |
| Ignition switch ON
Front seat belt (Driver Side) is fastened |
11 to 14 V | |||
| F38-25 (SW) - Body ground*1 | B - Body ground | Front seat inner belt assembly (Passenger Side) signal | Ignition switch ON Front passenger side seat occupied, seat belt unfastened | Below 1 V |
| Ignition switch ON Front passenger side seat occupied, seat belt fastened | 11 to 14 V |
*1: w/ Front Passenger Seat Belt Warning System
If the result is not as specified, there may be a malfunction in the wire harness.
DRIVER SIDE JUNCTION BLOCK ASSEMBLY
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Wiring Color | Terminal Description | Condition | Specified Condition |
|---|---|---|---|---|
| 2N-2 - Body ground | R - Body ground | Front seat inner belt assembly (driver side) signal | Ignition switch ON
Front seat belt (driver side) is unfastened |
Below 1 V |
| Ignition switch ON
Front seat belt (driver side) is unfastened |
11 to 14 V | |||
| 2M-4 - Body ground | P - Body ground | Ignition switch ON
Front seat belt (driver side) is unfastened |
Below 1 V | |
| Ignition switch ON
Front seat belt (driver side) is unfastened |
11 to 14 V |
If the result is not as specified, the driver side junction block assembly may have a malfunction.