Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › DECELERATION SENSOR › 2016.04–2017.10
RM30M0E _54 Brake _017098 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0264435 DECELERATION SENSOR G

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  DECELERATION SENSOR  INSPECTION  


PROCEDURE

Hide 89440A 1.CHECK DECELERATION SENSOR ASSEMBLY

a.

Check the deceleration sensor assembly.

Under any of the following conditions, replace the deceleration sensor assembly with a new one.

·

The surface of the sensor is cracked, dented, or chipped off.

·

The connector or wire harness is scratched, cracked, or damaged.

·

The sensor has been dropped.



Hide 89440A 2.INSPECT DECELERATION SENSOR ASSEMBLY

a.

Check the voltage.

i.
C286855C02
1.76,1.052 2.115,0.938 true 2.531,0.958 2.833,0.646 true 2.354,0.927 2.135,0.594 true 2.667,3.188 2.979,3.344 0.313,0.156 10 false *a 0.573,4.385 0.885,4.542 0.313,0.156 10 false *b 1.229,0.958 1.792,1.146 0.563,0.188 10 false 1 (VGS) 1.51,0.5 2.177,0.688 0.667,0.188 10 false 2 (GGND) 2.865,0.542 3.385,0.729 0.521,0.188 10 false 3 (GL1)
*a Forward
*b Rearward


Connect 3 dry cell batteries of 1.5 V in series (approximately 4.5 V total).


ii.

Connect the batteries' positive (+) lead to terminal 1 (VGS) and the negative (-) lead to terminal 2 (GGND).

NOTICE:

Do not apply 6 V or higher to terminals 1 (VGS) and 2 (GGND).



iii.

Connect the voltmeter's negative (-) lead to the negative (-) lead of the batteries, and the positive (+) lead to terminal 3 (GL1).


iv.

Check the output voltage of terminal 3 (GL1) when the sensor is tilted forward and rearward.

Standard Voltage:
Tester Connection Sensor Position Specified Condition
3 (GL1) - Battery's negative (-) lead Horizontal Approximately 2.25 V
3 (GL1) - Battery's negative (-) lead Tilted forward Approximately 2.25 to 4.05 V
3 (GL1) - Battery's negative (-) lead Tilted rearward Approximately 0.45 to 2.25 V


If the result is not as specified, replace the deceleration sensor assembly.

HINT:
·

If voltage drops, the deceleration sensor assembly should be replaced with a new one.

·

When replacing the deceleration sensor assembly, it should not be placed upside down.