Home › Engine / Hybrid System › 2NR-FE FUEL › FUEL PUMP › from 2016.04
RM30M0E _51 Engine / Hybrid System _053553 2NR-FE FUEL _0265575 FUEL PUMP G

2NR-FE FUEL  FUEL PUMP  INSPECTION  


PROCEDURE

Hide 23221 1.INSPECT FUEL PUMP

a.
A171358C05
1.635,0.594 1.438,0.24 true 1.854,0.594 2.052,0.24 true 1.302,0.156 1.417,0.323 0.115,0.167 10 false 1 2.083,0.156 2.198,0.323 0.115,0.167 10 false 2 0.167,0.167 0.333,0.333 0.167,0.167 10 false *a
*a Component without harness connected
(Fuel Pump)


Check the resistance.

i.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 - 2 20°C (68°F) 0.2 to 3.0 Ω


If the result is not as specified, replace the fuel pump.



b.

Check fuel pump operation.

i.

Connect the positive (+) lead of the battery to terminal 1 of the connector and negative (-) lead to terminal 2. Check that the fuel pump operates.

OK:

Fuel pump operating sound can be heard.


NOTICE:
·

This test must be done quickly (within 10 seconds) to prevent the coil from burning out.

·

Keep the fuel pump as far away from the battery as possible.

·

Always switch the voltage on and off at the battery, not the fuel pump.



If the fuel pump does not operate, replace the fuel pump.