Home › Engine / Hybrid System › 2NR-FE FUEL › FUEL SENDER GAUGE ASSEMBLY › from 2016.04
RM30M0E _51 Engine / Hybrid System _053553 2NR-FE FUEL _0265577 FUEL SENDER GAUGE ASSEMBLY G

2NR-FE FUEL  FUEL SENDER GAUGE ASSEMBLY  INSPECTION  


PROCEDURE

Hide 83320 1.INSPECT FUEL SENDER GAUGE ASSEMBLY

a.

Check that the float moves smoothly between F (Upper End) and E (Lower End).


b.
A288177C02
0.667,4.292 1.188,4.292 true 0.656,2.073 1.063,2.073 true 0.354,0.177 0.667,0.333 0.313,0.156 10 false *a 0.49,1.99 0.802,2.188 0.313,0.198 10 false *b 0.5,4.198 0.813,4.396 0.313,0.198 10 false *c
*a Component without harness connected
(Fuel Sender Gauge Assembly)
*b F (Upper End)
*c E (Lower End)


Check the resistance.

i.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 - 2 F (Upper End) 13.5 to 16.5 Ω
Between F (Upper End) - E (Lower End) 13.5 to 414.5 Ω
(Gradually Changes)
E (Lower End) 405.5 to 414.5 Ω


If the result is not as specified, replace the fuel sender gauge assembly.