Home › Engine / Hybrid System › CRUISE CONTROL › CRUISE CONTROL SYSTEM › from 2016.04
RM30M0E _51 Engine / Hybrid System _052909 CRUISE CONTROL _0256264 CRUISE CONTROL SYSTEM J

CRUISE CONTROL  CRUISE CONTROL SYSTEM  Clutch Switch Circuit  


DESCRIPTION

While depressing the clutch pedal, the clutch switch sends a signal to terminal (D) of the ECM. The ECM cancels cruise control when terminal (D) receives the signal.

WIRING DIAGRAM

C353770E01
0.385,0.927 2.677,1.125 2.292,0.198 10 false from IG Circuit 1.948,1.073 4.24,1.271 2.292,0.198 10 false ECU-IG NO.1 3.344,0.833 3.802,1.031 0.458,0.198 10 false CL+ 4.042,0.833 4.5,1.031 0.458,0.198 10 false CL- 4.417,0.833 4.875,1.031 0.458,0.198 10 false 2 3.115,0.833 3.573,1.031 0.458,0.198 10 false 1 2.885,1.458 5.177,1.656 2.292,0.198 10 false Clutch Start Switch Assembly 2.885,1.302 5.177,1.5 2.292,0.198 10 false A44 5.292,0.833 5.75,1.031 0.458,0.198 10 false 18 5.594,0.938 6.052,1.135 0.458,0.198 10 false D 5.802,1.938 6.417,2.156 0.615,0.219 10 false F130 5.802,2.104 6.417,2.323 0.615,0.219 10 false ECM

CAUTION / NOTICE / HINT

NOTICE:

Inspect the fuses for circuits related to this system before performing the following inspection procedure.


PROCEDURE

1.INSPECT CLUTCH START SWITCH ASSEMBLY
a.

Inspect the clutch start switch assembly.

HINT:

Click hereEngine / Hybrid System>CRUISE CONTROL>CLUTCH SWITCH>INSPECTION



Result:
Result Proceed to
OK A
NG B



A

2.CHECK HARNESS AND CONNECTOR (CLUTCH START SWITCH ASSEMBLY - ECM AND BATTERY)

B

REPLACE CLUTCH START SWITCH ASSEMBLY

2.CHECK HARNESS AND CONNECTOR (CLUTCH START SWITCH ASSEMBLY - ECM AND BATTERY)
a.

Disconnect the A44 clutch start switch assembly connector.


b.

Disconnect the F130 ECM connector.


c.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Switch Condition Specified Condition
A44-1 - Body ground Ignition switch ON 11 to 14 V
Ignition switch off Below 1 V



d.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
A44-2 - F130-18 (D) Always Below 1 Ω
A44-2 or F130-18(D) - Body ground Always 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR