Home › General › SPECIFICATIONS › 2NR-FE STARTING › from 2016.04
RM30M0E _V1 General _017290 SPECIFICATIONS _0273530 2NR-FE STARTING F

SPECIFICATIONS  2NR-FE STARTING  SERVICE DATA  


Starter assembly Standard current 90 A or less at 11.5 V
Starter armature assembly Standard resistance Segment - Segment Below 1Ω
Segment - armature core 10 kΩ higher
Brush Standard length 11.6 mm (0.457 in.)
Minimum length 7.6 mm (0.299 in.)
Starter brush holder assembly Standard resistance Positive (+) - Negative (-) 10 kΩ or higher
Magnet switch Standard resistance Terminal 50 - Terminal C Below 1Ω
Terminal 50 - Motor terminal starter kit Below 2 Ω
Ignition or starter switch assembly Standard resistance Between all terminals 10 kΩ or higher
2 (ACC) - 4 (AM1) Below 1 Ω (ACC)
1 (IG1) - 2 (ACC) - 4 (AM1) Below 1 Ω (ON)
5 (AM2) - 6 (IG2)
1 (IG1) - 4 (AM1) - 3 (ST1) Below 1 Ω (START)
5 (AM2) - 6 (IG2) - 7 (ST2)
Starter relay Standard resistance 3 - 5 10 kΩ or higher (Battery voltage not applied to terminals 1 and 2)
Below 1 Ω (Battery voltage applied to terminals 1 and 2)