Home › General › SPECIFICATIONS › CLUTCH › 2016.04–2016.07
RM30M0E _V1 General _017290 SPECIFICATIONS _0097234 CLUTCH F

SPECIFICATIONS  CLUTCH  SERVICE DATA  


Clutch Pedal
Pedal height from floor panel (for LHD) for 1NR-FE, 2NZ-FE 118.1 to 128.1 mm (4.65 to 5.04 in.)
for 2NR-FE, 1NZ-FE 133.1 to 143.1 mm (5.25 to 5.63 in.)
Pedal height from floor panel (for RHD) - 145 to 155 mm (5.71 to 6.10 in.)
Pedal free play - 5.0 to 15.0 mm (0.197 to 0.590 in.)
Push rod play at pedal top - 1.0 to 5.0 mm (0.0394 to 0.196 in.)
Clutch release point from pedal full stroke end position - 25 mm (0.984 in.) or more
Pedal stroke (Reference) for 1NR-FE, 2NZ-FE 120 to 130 mm (4.73 to 5.11 in.)
for 2NR-FE, 1NZ-FE 137 to 147 mm (5.40 to 5.78 in.)

Clutch Unit (for C50)
Clutch disc rivet depth Minimum 0.3 mm (0.0118 in.)
Clutch disc runout Maximum 0.8 mm (0.0315 in.)
Clutch cover diaphragm spring wear Maximum depth 0.5 mm (0.0197 in.)
Maximum width 6.0 mm (0.236 in.)
Flywheel runout Maximum 0.1 mm (0.00394 in.)
Clutch cover diaphragm spring tip non-alignment Maximum 0.5 mm (0.0197 in.)

Clutch Unit (for C54)
Clutch disc rivet depth Minimum 0.3 mm (0.0118 in.)
Clutch disc runout Maximum 0.8 mm (0.0315 in.)
Clutch cover diaphragm spring wear Maximum depth 0.5 mm (0.0197 in.)
Maximum width 6.0 mm (0.236 in.)
Flywheel runout Maximum 0.1 mm (0.00394 in.)
Clutch cover diaphragm spring tip non-alignment Maximum 0.5 mm (0.0197 in.)

Clutch Pedal Switch
Clutch start switch assembly resistance
1 - 2 On (Pushed in) Below 1Ω
Off (Released) 10 kΩ or higher
Clutch switch assembly resistance (w/ Cruise Control System)
1 - 2 On (Pushed in) Below 1Ω
Off (Released) 10 kΩ or higher

Brake Fluid
- SAE J1703 or FMVSS No. 116 DOT3