16361A
1.INSTALL FAN AND GENERATOR V BELT
| *1 | Crankshaft Damper Sub-assembly |
| *2 | Generator with Regulator Assembly |
| *3 | Engine Water Pump Assembly |
| *4 | Cooler Compressor Assembly |
Temporarily install the fan and generator V belt to each pulley.
Make sure that there is no foreign matter or liquid, such as oil, on the fan and generator V belt and pulleys.
Make sure that the fan and generator V belt is securely fitted into the rib grooves of the pulley.
16361A
2.ADJUST FAN AND GENERATOR V BELT
| *a | OK |
| *b | NG |
|
Front of Vehicle |
Insert an adjusting bar between the engine mounting insulator sub-assembly RH and generator with regulator assembly. Pull the adjusting bar toward the vehicle front to adjust the fan and generator V belt tension.
Do not insert the adjusting bar between the camshaft timing oil control valve assembly and generator with regulator assembly. It could damage the camshaft timing oil control valve assembly.
First tighten the bolt A, then tighten the bolt B.
16361A
3.INSPECT FAN AND GENERATOR V BELT
51441C
4.INSTALL ENGINE UNDER COVER RH
Install the engine under cover RH to the vehicle with the 2 bolts and 4 screws.