Home › Engine / Hybrid System › 1NR-FE ENGINE CONTROL › SFI SYSTEM › from 2016.07
RM30M0E _51 Engine / Hybrid System _053310 1NR-FE ENGINE CONTROL _0258661 SFI SYSTEM L

1NR-FE ENGINE CONTROL  SFI SYSTEM  PRECAUTION  


INITIALIZATION


NOTICE:
·

Perform Registration (VIN registration or frame number registration) when replacing the ECM.

Click hereEngine / Hybrid System>1NR-FE ENGINE CONTROL>SFI SYSTEM>REGISTRATION

·

If the ECM is replaced, register the ECU communication ID for Immobiliser System (refer to the registration procedures for Service Bulletin).

·

Make sure to perform Reset Memory (CVT initialization), deceleration sensor 0 point calibration and CVT oil pressure calibration when replacing the ECM (for CVT).

Click hereDrivetrain>K411 CVT>CONTINUOUSLY VARIABLE TRANSAXLE SYSTEM>INITIALIZATION

·

When the cable is disconnected from the negative (-) battery terminal, initialize the following system(s) after the cable is reconnected.

System Name See Procedure
Power Door Lock Control System (for Hatchback) (Click here)



HINT:

Initialization cannot be completed by only disconnecting and reconnecting the cable of the negative (-) battery terminal.


Powertrain > Engine and ECT > Data List
Tester Display
Vehicle Speed

WHEN USING GTS


CAUTION:

Observe the following items for safety reasons:


·

Before using the GTS, read the instruction manual.

·

Make sure that the GTS cable is not caught on the pedals, shift lever and steering wheel when driving with the GTS connected to the vehicle.

·

When driving the vehicle for testing purposes while using the GTS, 2 persons are required. One person drives the vehicle and the other operates the GTS.



IGNITION SWITCH EXPRESSIONS


HINT:

The type of ignition switch used on this model differs according to the specifications of the vehicle. The expressions listed in the table below are used in this section.

Expression Ignition Switch (Position) Engine Switch (Condition)
Ignition Switch off LOCK Off (Lock)
Ignition Switch ACC ACC On (ACC)
Ignition Switch ON ON On (IG)
Engine Start START On (Start)