58910C
1.REMOVE REAR CONSOLE BOX ASSEMBLY
89465
2.REMOVE HEATED OXYGEN SENSOR (for Sensor 1)
57533B
3.REMOVE FRONT FLOOR CENTER BRACE
Remove the 4 bolts and front floor center brace from the vehicle.
17410
4.REMOVE FRONT EXHAUST PIPE ASSEMBLY
Using a clip remover, remove the clip from the front floor carpet assembly.
Disengage the front floor carpet assembly and peel it back.
Disconnect the heated oxygen sensor connector.
Remove the heated oxygen sensor wire grommet and pass the connector through the hole to the outside of the vehicle.
Remove the 2 bolts and 2 compression springs to separate the front exhaust pipe assembly from the exhaust manifold.
Remove the 2 bolts and 2 compression springs to separate the front exhaust pipe assembly from the tail exhaust pipe assembly.
Disconnect the 3 exhaust pipe supports to remove the front exhaust pipe assembly from the vehicle.
Remove the 2 exhaust pipe gaskets from the exhaust manifold and front exhaust pipe assembly.
25591
5.REMOVE MANIFOLD SUPPORT BRACKET
Remove the 3 bolts and manifold support bracket from the exhaust manifold and cylinder block sub-assembly.
17141
6.REMOVE EXHAUST MANIFOLD
Remove the 3 bolts, 2 nuts and exhaust manifold from the cylinder head sub-assembly.
Remove the exhaust manifold to head gasket from the cylinder head sub-assembly.