Home › Suspension › TIRE PRESSURE MONITORING › TIRE PRESSURE WARNING SYSTEM › from 2016.07
RM30M0E _53 Suspension _057557 TIRE PRESSURE MONITORING _0280386 TIRE PRESSURE WARNING SYSTEM J

TIRE PRESSURE MONITORING  TIRE PRESSURE WARNING SYSTEM  ECU Power Source Circuit  


DESCRIPTION

The IG circuit is the power source for the tire pressure warning ECU and receiver.

WIRING DIAGRAM

C349070E02
0.896,0.625 3.188,0.823 2.292,0.198 10 false from IG Circuit 3.135,0.771 5.427,0.969 2.292,0.198 10 false ECU-IG NO. 1 5.042,0.646 7.156,0.906 2.115,0.26 10 false IG 5.042,1.708 7.156,1.969 2.115,0.26 10 false GND 4.74,1.594 5.177,1.792 0.438,0.198 10 false 12 4.823,0.531 5.26,0.729 0.438,0.198 10 false 1 4.167,2 6.281,2.26 2.115,0.26 10 false F134 4.167,2.167 6.76,2.5 2.594,0.333 10 false Tire Pressure Warning ECU and Receiver

CAUTION / NOTICE / HINT

NOTICE:
·

When replacing the tire pressure warning ECU and receiver, read the transmitter IDs stored in the old ECU using the GTS and write them down before removal.

·

It is necessary to perform initializationSuspension>TIRE PRESSURE MONITORING>TIRE PRESSURE WARNING SYSTEM>INITIALIZATION after registrationSuspension>TIRE PRESSURE MONITORING>TIRE PRESSURE WARNING SYSTEM>REGISTRATION of the transmitter IDs into the tire pressure warning ECU and receiver if the ECU has been replaced.



HINT:

Inspect the fuses for circuits related to this system before performing the following inspection procedure.


PROCEDURE

1.CHECK HARNESS AND CONNECTOR (TIRE PRESSURE WARNING ECU AND RECEIVER - BATTERY AND BODY GROUND)
a.
C363479C01
0.229,0.729 0.729,0.979 0.5,0.25 0.771,1.688 1.208,1.25 true 2.25,1.448 2.74,1.708 true 0.323,0.771 0.938,0.969 0.615,0.198 10 false F134 0.115,0.115 0.729,0.313 0.615,0.198 10 false *a 0.573,1.604 0.917,1.854 0.344,0.25 10 false IG 2.813,1.625 3.427,1.823 0.615,0.198 10 false GND
*a Front view of wire harness connector
(to Tire Pressure Warning ECU and Receiver)


Disconnect the tire pressure warning ECU and receiver connector.


b.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Switch Condition Specified Condition
F134-1 (IG) - Body ground Ignition switch ON 10 to 16 V
Ignition switch off Below 1 V



c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
F134-12 (GND) - Body ground Always Below 1 Ω



Result:
Result Proceed to
OK (for Sedan) A
OK (for Hatchback) B
NG C



A

REPLACE TIRE PRESSURE WARNING ECU AND RECEIVER

B

C

REPAIR OR REPLACE HARNESS OR CONNECTOR