Home › Suspension › TIRE PRESSURE MONITORING › TIRE PRESSURE WARNING SYSTEM › from 2016.07
RM30M0E _53 Suspension _057557 TIRE PRESSURE MONITORING _0280386 TIRE PRESSURE WARNING SYSTEM J

TIRE PRESSURE MONITORING  TIRE PRESSURE WARNING SYSTEM  TC and CG Terminal Circuit  


DESCRIPTION

Tire pressure warning system DTCs can be checked by connecting terminals 13 (TC) and 4 (CG) of the DLC3. The DTCs are indicated by blinking the tire pressure warning light.

WIRING DIAGRAM

C349072E02
1.458,0.698 1.771,0.896 0.313,0.198 10 false TC 1.427,1.313 1.74,1.51 0.313,0.198 10 false CG 1.781,0.594 2.094,0.792 0.313,0.198 10 false 13 1.792,1.208 2.104,1.406 0.313,0.198 10 false 4 1.031,1.833 1.344,2.031 0.313,0.198 10 false F16 1.031,2 1.646,2.198 0.615,0.198 10 false DLC3 5.188,1.823 5.635,2.021 0.448,0.198 10 false F134 5.188,1.99 6.615,2.49 1.427,0.5 10 false Tire Pressure Warning ECU and Receiver 5.427,0.698 5.74,0.896 0.313,0.198 10 false TC 5.198,0.594 5.51,0.792 0.313,0.198 10 false 3

PROCEDURE

1.CHECK HARNESS AND CONNECTOR (DLC3 - TIRE PRESSURE WARNING ECU AND RECEIVER AND BODY GROUND)
a.

Disconnect the F134 tire pressure warning ECU and receiver connector.


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
F16-13 (TC) - F134-3 (TC) Always Below 1 Ω
F16-13 (TC) or F134-3 (TC) - Body ground Always 10 kΩ or higher
F16-4 (CG) - Body ground Always Below 1 Ω



Result:
Proceed to
OK
NG



OK

CHECK PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR OR EACH ECU