58910C
1.REMOVE REAR CONSOLE BOX ASSEMBLY
2.ADJUST SHIFT LEVER POSITION
Apply the parking brake and move the shift lever to N.
Disconnect the end of the transmission control cable assembly from the transmission floor shift assembly.
| *1 | Adjuster Case |
| *2 | Cover |
|
Slide |
Slide the cover in the direction shown by the arrow.
| *1 | Adjuster Case |
| *2 | Lock Piece |
|
Pull Out |
Using a screwdriver, pull out the lock piece.
Confirm that the shift lever is in N, and then connect the end of the transmission control cable assembly to the transmission floor shift assembly.
Securely install the end of the transmission control cable assembly to the transmission floor shift assembly.
Install the end of the transmission control cable assembly so that its adjustment lock section is on the driver side.
| *1 | Cable Rod |
|
Pull |
Using your fingers, gently pull the cable rod towards the rear of the vehicle to remove backlash.
| *1 | Adjuster Case |
| *2 | Lock Piece |
|
Push |
Push in the lock piece to lock it.
| *1 | Adjuster Case |
| *2 | Lock Piece |
| *3 | Cover |
|
Slide |
Slide the cover in the direction shown by the arrow.
If the cover is not moved far enough, it will not engage with the lock piece, the cable rod will not be able to lock, and reliable shift operation will not be possible.
58910C
3.INSTALL REAR CONSOLE BOX ASSEMBLY