Home › Engine / Hybrid System › 2NZ-FE ENGINE CONTROL › HEATED OXYGEN SENSOR(for Sensor 2) › 2016.07–2016.10
RM30M0E _51 Engine / Hybrid System _017072 2NZ-FE ENGINE CONTROL _0091229 HEATED OXYGEN SENSOR(for Sensor 2) A

2NZ-FE ENGINE CONTROL  HEATED OXYGEN SENSOR(for Sensor 2)  REMOVAL  


PROCEDURE

Hide 89465A 2.REMOVE HEATED OXYGEN SENSOR (for Sensor 2)

a.
A171154

Using a clip remover, remove the clip from the front floor carpet assembly.


b.

Disengage the front floor carpet assembly and peel it back.


c.
A171155

Disconnect the heated oxygen sensor connector.


d.

Remove the grommet of the heated oxygen sensor and pass the connector through the hole to the outside of the vehicle.


e.
A171203E01
1.99,0.563 2.469,0.219 true 2.521,0.135 2.979,0.333 0.458,0.198 10 false SST

Using SST, remove the heated oxygen sensor from the front exhaust pipe assembly.

SST
09224-00010  

NOTICE:

If a component has been dropped or subjected to a strong impact, replace the heated oxygen sensor.