Home › Engine / Hybrid System › 2NZ-FE ENGINE CONTROL › HEATED OXYGEN SENSOR(for Sensor 2) › 2016.07–2016.10
RM30M0E _51 Engine / Hybrid System _017072 2NZ-FE ENGINE CONTROL _0091229 HEATED OXYGEN SENSOR(for Sensor 2) A

2NZ-FE ENGINE CONTROL  HEATED OXYGEN SENSOR(for Sensor 2)  INSTALLATION  


PROCEDURE

Hide 89465A 1.INSTALL HEATED OXYGEN SENSOR (for Sensor 2)

a.
A171204C01
1.906,0.938 2.479,0.5 true 0.417,3.177 0.729,3.333 0.313,0.156 10 false *a 1.51,3.167 1.823,3.323 0.313,0.156 10 false *b 2.5,0.417 2.958,0.615 0.458,0.198 10 false SST
*a Fulcrum Length 30 mm
*b Fulcrum Length 300 mm


Using SST, install the heated oxygen sensor to the front exhaust pipe assembly.

SST
09224-00010  

Torque:
without SST : 44 N*m (449 kgf*cm, 32 ft.*lbf)
with SST : 40 N*m (408 kgf*cm, 30 ft.*lbf)

NOTICE:

If a component has been dropped or subjected to a strong impact, replace the heated oxygen sensor.


HINT:
·

This torque value is effective when SST is parallel to the torque wrench.

·

The "with SST" torque value is effective when using SST with a fulcrum length of 30 mm (1.18 in.).

·

The "with SST" torque value is effective when using a torque wrench with a fulcrum length of 300 mm (11.81 in.).

·

If using a torque wrench with a different length, or connecting the torque wrench and SST at an angle, refer to the alternate torque values.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION




b.
A171153

Pass the connector through the hole to the inside of the vehicle and install the grommet of the heated oxygen sensor.


c.

Connect the heated oxygen sensor connector.


d.

Return the front floor carpet assembly and engage it.


e.

Install the clip to the front floor carpet assembly.


Hide 3.INSPECT FOR EXHAUST GAS LEAK