Home › Engine / Hybrid System › 1NZ-FE LUBRICATION › LUBRICATION SYSTEM › 2016.07–2016.10
RM30M0E _51 Engine / Hybrid System _017083 1NZ-FE LUBRICATION _0091238 LUBRICATION SYSTEM G

1NZ-FE LUBRICATION  LUBRICATION SYSTEM  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 1.CHECK ENGINE OIL LEVEL

a.

Warm up and stop the engine, then wait for 5 minutes.


b.

Check that the engine oil level is between the low level and full level marks on the engine oil level dipstick.

If the level is low, check for engine oil leaks and add engine oil to the full level mark.

NOTICE:

Do not fill to above the full level mark.


HINT:

A certain amount of engine oil will be consumed while driving. In the following situations, oil consumption may increase, and engine oil may need to be refilled in between oil maintenance intervals.

·

When the engine is new, for example directly after purchasing the vehicle or after replacing the engine.


·

If low quality oil or oil of an inappropriate viscosity is used.


·

When driving at high engine speed or with a heavy load (when towing), when driving while accelerating or decelerating frequently.


·

When leaving the engine idling for a long time, or when driving frequently through heavy traffic. When judging the amount of oil consumption, keep in mind that the oil may have become diluted, making it difficult to judge the true level accurately.




Hide 2.CHECK ENGINE OIL QUALITY

a.

Check the engine oil for deterioration, water intrusion, discoloration or thinning.

If the quality is visibly poor, replace the engine oil.


Hide 3.INSPECT OIL PRESSURE

a.

Remove the engine oil pressure switch assembly.

Click hereEngine / Hybrid System>1NZ-FE LUBRICATION>OIL PRESSURE SWITCH>REMOVAL


b.
A104878

Install the oil pressure gauge to the cylinder block sub-assembly.


c.

Warm up engine.


d.

Inspect the oil pressure.

Standard Oil Pressure:
At Idle At 3000 rpm
29 kPa (0.3 kgf/cm2, 4.4 psi) or more 150 to 550 kPa (1.5 to 5.6 kgf/cm2, 22 to 80 psi)


If the oil pressure is not as specified, check the oil pump assembly.


e.

Remove the oil pressure gauge from the cylinder block sub-assembly.


f.

Install the engine oil pressure switch assembly.

Click hereEngine / Hybrid System>1NZ-FE LUBRICATION>OIL PRESSURE SWITCH>INSTALLATION