Home › Engine / Hybrid System › 1NZ-FE LUBRICATION › OIL PRESSURE SWITCH › 2016.07–2016.10
RM30M0E _51 Engine / Hybrid System _017083 1NZ-FE LUBRICATION _0091240 OIL PRESSURE SWITCH G

1NZ-FE LUBRICATION  OIL PRESSURE SWITCH  INSPECTION  


PROCEDURE

Hide 83530 1.INSPECT ENGINE OIL PRESSURE SWITCH ASSEMBLY

a.

Disconnect the engine oil pressure switch assembly connector.


b.

Start the engine.


c.
A159695

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 - Switch body Idling 10 kΩ or higher
Engine stopped Below 1 Ω


If the result is not as specified, replace the engine oil pressure switch assembly.


d.

Reconnect the engine oil pressure switch assembly connector.