51442C
1.REMOVE ENGINE UNDER COVER LH
for Automatic Transaxle:
Click hereEngine / Hybrid System>2NZ-FE ENGINE MECHANICAL>ENGINE ASSEMBLY(for Automatic Transaxle)>REMOVAL
for Manual Transaxle:
Click hereEngine / Hybrid System>2NZ-FE ENGINE MECHANICAL>ENGINE ASSEMBLY(for Manual Transaxle)>REMOVAL
51441C
2.REMOVE ENGINE UNDER COVER RH
for Automatic Transaxle:
Click hereEngine / Hybrid System>2NZ-FE ENGINE MECHANICAL>ENGINE ASSEMBLY(for Automatic Transaxle)>REMOVAL
for Manual Transaxle:
Click hereEngine / Hybrid System>2NZ-FE ENGINE MECHANICAL>ENGINE ASSEMBLY(for Manual Transaxle)>REMOVAL
83530
3.REMOVE ENGINE OIL PRESSURE SWITCH ASSEMBLY
Disconnect the engine oil pressure switch assembly connector.
| *a | 24 mm Deep Socket Wrench |
Using a 24 mm deep socket wrench, remove the engine oil pressure switch assembly from the cylinder block sub-assembly.