1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notice before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
11363A
3.REMOVE FLYWHEEL HOUSING SIDE COVER
Disengage the claw while pulling it upward and remove the flywheel housing side cover.
28100
4.REMOVE STARTER ASSEMBLY
| *1 | Terminal Cap |
Open the terminal cap.
Remove the nut to disconnect the terminal 30 from the magnet starter switch assembly.
Disconnect the terminal 50 connector.
Remove the 2 bolts and starter assembly from the cylinder block sub-assembly and oil pan sub-assembly.