Home › Vehicle Interior › HEATING / AIR CONDITIONING › AIR CONDITIONING SYSTEM(for Manual Air Conditioning System) › 2016.10–2017.10
RM30M0E _58 Vehicle Interior _017118 HEATING / AIR CONDITIONING _0086991 AIR CONDITIONING SYSTEM(for Manual Air Conditioning System) J

HEATING / AIR CONDITIONING  AIR CONDITIONING SYSTEM(for Manual Air Conditioning System)  IG Power Source Circuit  


DESCRIPTION

The main power source supplied to the air conditioning amplifier assembly when the ignition switch is turned to ON. The power source is used for operating components, such as the air conditioning amplifier assembly.

WIRING DIAGRAM

E275738E04
4.5,0.646 4.813,0.844 0.313,0.198 10 false 1 4.698,0.729 5.01,0.927 0.313,0.198 10 false IG+ 4.698,1.292 5.01,1.49 0.313,0.198 10 false GND 4.458,1.198 4.771,1.396 0.313,0.198 10 false 14 4.375,1.979 4.896,2.177 0.521,0.198 10 false F124 4.365,2.135 6.583,2.323 2.219,0.188 10 false Air Conditioning Amplifier Assembly 2.656,0.875 3.594,1.063 0.938,0.188 10 false ECU-IG NO. 1 0.323,0.573 1.781,1.115 1.458,0.542 10 false from Ignition or Starter Switch Assembly*1 or No. 1 Ignition Relay*2 0.323,2.313 2.74,2.51 2.417,0.198 10 false *2: w/ Smart Entry and Start System 0.313,1.958 2.729,2.156 2.417,0.198 10 false *1: w/o Smart Entry and Start System


CAUTION / NOTICE / HINT

NOTICE:

Inspect the fuses for circuits related to this system before performing the following procedure.


PROCEDURE

1.CHECK HARNESS AND CONNECTOR (AIR CONDITIONING AMPLIFIER ASSEMBLY - POWER SOURCE)
a.
E281476C32
1.458,0.167 1.958,0.417 0.5,0.25 0.323,1.177 0.198,1.677 true 1.563,0.208 2.135,0.469 0.573,0.26 10 false F124 0.104,1.688 0.417,1.896 0.313,0.208 10 false IG+ 0.146,0.104 0.458,0.302 0.313,0.198 10 false *a
*a Front view of wire harness connector (to Air Conditioning Amplifier Assembly)


Disconnect the air conditioning amplifier assembly connector.


b.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Switch Condition Specified Condition
F124- 1 (IG+) - Body ground Ignition switch off Below 1 V
F124- 1 (IG+) - Body ground Ignition switch ON 11 to 14 V



Result:
Proceed to
OK
NG



OK

2.CHECK HARNESS AND CONNECTOR (AIR CONDITIONING AMPLIFIER ASSEMBLY - BODY GROUND)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

2.CHECK HARNESS AND CONNECTOR (AIR CONDITIONING AMPLIFIER ASSEMBLY - BODY GROUND)
a.
E281476C33
1.458,0.167 1.958,0.417 0.5,0.25 2.177,1.188 2.021,1.698 true 1.552,0.208 2.177,0.396 0.625,0.188 10 false F124 1.865,1.698 2.177,1.906 0.313,0.208 10 false GND 0.104,0.073 0.417,0.271 0.313,0.198 10 false *a
*a Front view of wire harness connector (to Air Conditioning Amplifier Assembly)


Disconnect the air conditioning amplifier assembly connector.


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
F124- 14 (GND) - Body ground Always Below 1 Ω



Result:
Proceed to
OK
NG



OK

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR