RM30M0E
_V1
General
_017290
SPECIFICATIONS
_0097234
CLUTCH
F
SPECIFICATIONS CLUTCH SERVICE DATA
Clutch Pedal
| Pedal height from floor panel (for LHD)
|
for 1NR-FE
|
118.1 to 128.1 mm (4.65 to 5.04 in.)
|
| for 2NR-FE
|
133.1 to 143.1 mm (5.25 to 5.63 in.)
|
| Pedal height from floor panel (for RHD)
|
-
|
145 to 155 mm (5.71 to 6.10 in.)
|
| Pedal free play
|
-
|
5.0 to 15.0 mm (0.197 to 0.590 in.)
|
| Push rod play at pedal top
|
-
|
1.0 to 5.0 mm (0.0394 to 0.196 in.)
|
| Clutch release point from pedal full stroke end position
|
-
|
25 mm (0.984 in.) or more
|
| Pedal stroke (Reference)
|
for 1NR-FE
|
120 to 130 mm (4.73 to 5.11 in.)
|
| for 2NR-FE
|
137 to 147 mm (5.40 to 5.78 in.)
|
Clutch Unit (for C50)
| Clutch disc rivet depth
|
Minimum
|
0.3 mm (0.0118 in.)
|
| Clutch disc runout
|
Maximum
|
0.8 mm (0.0315 in.)
|
| Clutch cover diaphragm spring wear
|
Maximum depth
|
0.5 mm (0.0197 in.)
|
| Maximum width
|
6.0 mm (0.236 in.)
|
| Flywheel runout
|
Maximum
|
0.1 mm (0.00394 in.)
|
| Clutch cover diaphragm spring tip non-alignment
|
Maximum
|
0.5 mm (0.0197 in.)
|
Clutch Unit (for C54)
| Clutch disc rivet depth
|
Minimum
|
0.3 mm (0.0118 in.)
|
| Clutch disc runout
|
Maximum
|
0.8 mm (0.0315 in.)
|
| Clutch cover diaphragm spring wear
|
Maximum depth
|
0.5 mm (0.0197 in.)
|
| Maximum width
|
6.0 mm (0.236 in.)
|
| Flywheel runout
|
Maximum
|
0.1 mm (0.00394 in.)
|
| Clutch cover diaphragm spring tip non-alignment
|
Maximum
|
0.5 mm (0.0197 in.)
|
Clutch Pedal Switch
| Clutch start switch assembly resistance
|
| 1 - 2
|
On (Pushed in)
|
Below 1Ω
|
| Off (Released)
|
10 kΩ or higher
|
| Clutch switch assembly resistance (w/ Cruise Control System)
|
| 1 - 2
|
On (Pushed in)
|
Below 1Ω
|
| Off (Released)
|
10 kΩ or higher
|
Brake Fluid
| -
|
SAE J1703 or FMVSS No. 116 DOT3
|